DE2023/0250/DEIntroduced

Mitteilung 001

Jurisdiction:
Germany
Type:
EPR · Incentives
Last action:
May 26, 2023
Plastic Packaging
Next steps for producers

Review this measure’s obligations and confirm whether they reach your products

Applies toManufacturers (Hersteller) of certain single-use plastic products who place those products on the market in Germany

Obligations under this law
  • ·Pay a single-use plastic levy (Einwegkunststoffabgabe) into the single-use plastics fund (EWKFonds) managed by the Federal Environment Agency (Umweltbundesamt)
  • ·Calculate and pay the levy based on the nature and mass of single-use plastic products placed on the market
  • ·Comply with levy rates set by the Single-Use Plastics Fund Regulation (EWKFondsV)

No designated program action is recorded for this measure yet — treat the above as the general obligation and verify against the source text.

Germany's Single-Use Plastics Fund Regulation (EWKFondsV) establishes a producer-responsibility financing mechanism for single-use plastic products listed in EU Directive 2019/904, creating levy rates and a points system to fund waste-reduction and circular-economy outcomes; notified under TRIS with standstill ending 2023-08-30, indicating imminent adoption.
Covered Products
  • ·Single-use plastic products listed in Part E of the Annex to Directive (EU) 2019/904 (Single-Use Plastics Directive)
Producer Obligations
  • ·Pay a single-use plastic levy (Einwegkunststoffabgabe) into the single-use plastics fund (EWKFonds) managed by the Federal Environment Agency (Umweltbundesamt)
  • ·Calculate and pay the levy based on the nature and mass of single-use plastic products placed on the market
  • ·Comply with levy rates set by the Single-Use Plastics Fund Regulation (EWKFondsV)
Key Deadlines
Aug 30, 2023other: End of TRIS standstill period; regulation cannot be adopted before this date
Producer Definition
Manufacturers (Hersteller) of certain single-use plastic products who place those products on the market in Germany
Fee Structure
Per Ton: Levy calculated on the basis of the nature and mass of single-use plastic products placed on the market. Specific rates are set by the EWKFondsV statutory order. Disbursements from the fund to public-law waste management authorities are determined by a points system based on the nature and extent of services provided.
Enforcement
Federal Environment Agency (Umweltbundesamt):
Preemption Notes
This is a TRIS notification under Directive (EU) 2015/1535; the measure is a draft not yet adopted. The standstill period ends 2023-08-30. The regulation transposes Article 8(1-7) of Directive (EU) 2019/904 (Single-Use Plastics Directive) and is grounded in EU law.
Compliance Dimensions
FeesUnspecified — Single-use plastic products listed in Part E of the Annex to Directive (EU) 2019/904; specific rates to be set by EWKFondsV

“Die vorliegende Einwegkunststofffondverordnung (EWKFondsV) legt die Sätze für die Einwegkunststoffabgabe und ein Punktesystem als Kriterium für die Auszahlung von Mitteln aus dem Einwegkunststofffonds fest.”

PRO StructureGovernment Run

“Das Einwegkunststofffondgesetz (EWKFondsG) (BGBl. 2023 I Nr. 124) hat die Rechtsgrundlage für die Bildung und Verwaltung eines Einwegkunststofffonds durch das Umweltbundesamt, für die Erhebung einer Einwegkunststoffabgabe von den Herstellern bestimmter Einwegkunststoffprodukte und für die Auszahlung von Mitteln an die öffentlich-rechtlichen Entsorgungsträger und andere anspruchsberechtigte juristische Personen des öffentlichen Rechts geschaffen.”

Tracking dates like these across a whole portfolio of jurisdictions is what Upcoming Deadlines does.

Full bill text

TRIS notification 2023/0250/DE — draft technical regulation notified under Directive (EU) 2015/1535 (not yet adopted)

Mitteilung 001

End of standstill: 2023-08-30

1. MSG 001 IND 2023 0250 DE EN 26-05-2023 DE NOTIF
2. Germany
4. 2023/0250/DE - S20E - Waste
Mitteilung 001
Mitteilung der Kommission - TRIS/(2023) 1399
Richtlinie (EU) 2015/1535
Notifizierung: 2023/0250/DE
Mitteilung eines Entwurfstextes eines Mitgliedstaats
Notification – Notification – Notifzierung – Нотификация – Oznámení – Notifikation – Γνωστοποίηση – Notificación – Teavitamine – Ilmoitus – Obavijest – Bejelentés – Notifica – Pranešimas – Paziņojums – Notifika – Kennisgeving – Zawiadomienie – Notificação – Notificare – Oznámenie – Obvestilo – Anmälan – Fógra a thabhairt
Does not open the delays - N'ouvre pas de délai - Kein Fristbeginn - Не се предвижда период на прекъсване - Nezahajuje prodlení - Fristerne indledes ikke - Καμμία έναρξη προθεσμίας - No abre el plazo - Viivituste perioodi ei avata - Määräaika ei ala tästä - Ne otvara razdoblje kašnjenja - Nem nyitja meg a késéseket - Non fa decorrere la mora - Atidėjimai nepradedami - Atlikšanas laikposms nesākas - Ma jiftaħx il-perijodi ta’ dewmien - Geen termijnbegin - Nie otwiera opóźnień - Não inicia o prazo - Nu deschide perioadele de stagnare - Nezačína oneskorenia - Ne uvaja zamud - Inleder ingen frist - Ní osclaíonn sé na moilleanna
MSG: 20231399.DE
1.	MSG 001 IND 2023 0250 DE DE 26-05-2023 DE NOTIF
2.	Germany
4.	2023/0250/DE - S20E - Waste
5.	Regulation on the levy rates and points system of the single-use plastics fund (Single-Use Plastics Fund Regulation - EWKFondsV)
6.	Products concerned are those listed in Part E of the Annex to Directive (EU) 2019/904 of the European Parliament and of the Council of 5 June 2019 on the reduction of the impact of certain plastic products on the environment (Single-Use Plastics Directive).
7.
8.	The Single-Use Plastics Fund Act (EWKFondsG) (BGBl. 2023 I No 124) has created the legal basis for the formation and management of a single-use plastic fund by the Federal Environment Agency, for the collection of a single-use plastic levy from the manufacturers of certain single-use plastic products and for the payment of funds to the
public-law waste management authorities and other legal entities
under public law who are entitled to claim.
Manufacturers of certain single-use plastic products shall bear certain costs incurred by the public authorities for waste management, public cleaning and awareness-raising activities, which have up to now been financed by the general public. The manufacturers of the single-use plastic products concerned pay the single-use plastic levy into the fund as a special levy with a financing function, and the public-law waste management authorities and other entitled legal entities under public law receive reimbursement for their costs incurred from the fund. The levy shall be calculated on the basis of the nature and mass of the single-use plastic products which they place on the market, the amounts of money to be paid out according to the nature and extent of the services provided.
The present single-use plastics fund regulation (EWKFondsV) sets the rates for single-use plastics levy and a point system as a criterion for disbursement of funds from the single-use plastics fund.
9.	The Single-Use Plastics Fund Act (EWKFondsG) as set out in point 8 above transposes the requirements on extended manufacturer responsibility in accordance with Article 8(1-7) of Directive (EU) 2019/904 of the European Parliament and of the Council of 5 June 2019 on the reduction of the impact of certain plastic products on the environment.
The EWKFondsG contains two regulatory appropriations: The rates
for the single-use plastic levy and the point system for the payment of funds from
the single-use plastic fund shall be determined in accordance with Section 14(1 and 2) and Section 19(2 and 3)
EWKFondsG by statutory order of the Federal Ministry for the Environment, Nature Conservation,
Nuclear Safety and Consumer Protection. This shall be done by the present Single-Use Plastics Fund Regulation (EWKFondsV).
10.	Reference to the basic texts:
11.	No
12.
13.	No
14.	No
15.	No
16.
TBT aspect: No
PLC aspect: No

Full text as ingested. Verify against the official source above.

Explore more circular-economy legislation on the Atlas Circular legislation tracker.